Advertisement
Screw Retainers
Front Base
11
• Fit the frame front legs onto the front base.
• Fit a screw retainer over the hole in a front leg.
• Insert a #10 x 2,2 cm black screw through the screw
retainer and front leg. Tighten the screw.
• Repeat this procedure to fasten the other end of the front
base with the remaining screw retainer and
#10 x 2,2 cm black screw.
Hint: The #10 x 2,2 cm black screws may have been
assembled to the screw retainers.
PuSH
1
• Push each seat height adjuster to be sure they are
completely on the seat bottom tubes.
• Insert a #8 x 1,9 cm screw through each seat height
adjuster and the ends of the seat bottom tube. Tighten
the screws. This may require extra force.
Assembly
Seat Height Adjusters
13
• From the back and bottom of the assembly, insert a #8 x 1,9 cm
screw through both seat height adjusters and the ends of
the seat bottom tube. Tighten the screws. This may require
extra force.
PRESS
PuSH
1
• Squeeze the restraint release tabs together.
• Remove the ends of the restraint system from the peg.
7
Seat Bottom Tube Ends
PRESS
Advertisement
