Vgchange(1M) - HP -UX 11i Administrator's Manual

Cause
The vgcfgrestore command was used to initialize a disk that already belongs to an active
volume group.
Recommended Action
Detach the physical volume or deactivate the volume group before attempting to restore the physical
volume. If the disk may be corrupted, detach the disk and mark it using vgcfgrestore, then
attach it again without replacing the disk. This causes LVM to reinitialize the disk and synchronize
any mirrored user data mapped there.

vgchange(1M)

Message Text
vgchange: WARNING: The "lvmp" driver is not loaded.
Cause
You are activating a Version 2.x volume group, and the kernel driver for Version 2.x volume groups
is not loaded.
Recommended Action
Load the lvmp driver, as follows:
# kcmodule lvmp=best
==> Update the automatic 'backup' configuration first? n
* Future operations will ask whether to update the backup.
* The requested changes have been applied to the currently
running configuration.
Module
lvmp (before)
(now)
(next boot)
Message Text
vgchange: Warning: Couldn't attach to the volume group
physical volume "pvname":
Illegal byte sequence
vgchange: Couldn't activate volume group "vgname":
Quorum not present, or some physical volume(s) are missing.
Cause
You are activating a Version 2.x volume group, and your operating system release does not support
Version 2.x volumes.
Recommended Action
Update your system to the March 2008 release of HP-UX 1 1i Version 3 or a newer release.
Message Text
Warning: couldn't query physical volume "pvname":
The specified path does not correspond to physical volume
attached to this volume group
Couldn't query the list of physical volumes.
Cause
This error has the following possible causes:
State Cause
unused
loaded best
loaded explicit
Notes
loadable, unloadable
vgchange(1M) 167