Renaming Symbols - HP eld Manual

Other eld Processing
input files contained C++. An informational message is generated if the input files
contained C++.
When is creating a loadfile it also performs C++ dialect checking against all the
eld
DLL's that it sees as part of that load. The check is that no DLL has the opposite C++
dialect from that seen in an input linkfile.
Note that the use of -set CplusPlusDialect cppneutral does not affect this
check. If this check fails a warning message is generated; it is not considered an error
because different DLL's might be used at runtime.

Renaming Symbols

The -rename option affects how the linker treats each input linkfile as it is reading it in.
This option takes two parameters, symbol-1 and symbol-2. The option has no effect
unless this linkfile defines a global symbol named symbol-1.
same linkfile also defines a global symbol named symbol-2. The linkfile that defined
symbol-1 is now considered to define a symbol named symbol-2, with the same
properties that symbol-1 had. The linkfile is still considered to declare a symbol named
symbol-1, with the same properties as before, except that it is now an external
reference rather than a definition.
As a result, if the object file being built would have defined a symbol named symbol-1,
it will now define symbol-2 instead. If there were references to symbol-1, those will still
refer to symbol-1, and therefore they could not be resolved within this same object file.
If a new linkfile is being built with the -r option, a future link could combine this linkfile
with another one that supplied a definition of symbol-1, to satisfy such references. Or,
in general, the references could be satisfied in other DLLs.
One purpose of this option is to allow one copy of symbol-1 to be replaced by another
one, without having to recompile the source that created the linkfile containing symbol-
1. For example, the given object file that defines symbol-1 may be put through the
linker with the -r and -rename options to create another linkfile that no longer
defines symbo1, and then that linkfile could be linked with another one that provides a
different definition of symbol-1. For this purpose it is not necessary that the name
symbol-2 ever be referenced. However, when a procedure is renamed, the new version
of symbol-1 might wish to do the same things that the older symbol-1 would have
done, plus some new things. It could do this by calling symbol-2 to do the old stuff, and
having additional code for the new stuff.
Any number of -rename options may be in the command stream. They all apply to all
the input linkfiles, regardless of where they occur in the command stream. As each
input linkfile is processed, the linker does the processing described above for each
-rename option, in the order that the -rename options appeared in the command
stream.
eld Manual—527255-009
4-13
Renaming Symbols
reports an error if this
eld