HP eld Manual page 152

Output Listings and Error Handling
the reference was (in terms of its index in a table of relocation sites for some input
section), and which section it was pointing at (i.e., the section that was removed).
Effect. Fatal error (eld immediately stops without creating an output file).
Recovery. Assuming this file was created by the C++ compiler, that indicates a
compiler error, to be reported to HP, or perhaps incorrect usage of the compiler.
ENOFT can provide more information about the parts of the object file mentioned in the
message.
1276 <filename> contains the same DLL name as <filename>, and
is therefore being ignored.
Cause. While doing this link, and looking at other DLLs to resolve references, eld has
come upon the same DLL twice, where "same" means that it contains the same "DLL
name" inside it. These DLLs may have been found from items placed on the command
line, or indirectly through the liblist entries of other DLLs, or a combination of these
things. When looking for indirect DLLs, it is perfectly reasonable to find the same DLL
more than once, and usually eld is silent about that. In this case, eld put out a
warning message, because eld has not found the same file twice, nor two files that
look like copies of each other. In other words, it looks like there are two different DLLs
that just happen to have the same DLL name inside them, which is probably not
something you meant to do. The determination of whether two DLLs "look like copies
of each other" is based on whether they contain the same "export digest" within them.
Having the same export digest means that eld could use either copy of the DLL and
the resulting fixups of the file being created would come out exactly the same.
Effect. Warning (eld produces an output file, but it might not be what you intended).
Recovery. You should figure out what these two DLLs are and decide which one you
probably wanted eld to find, and which one you didn't want eld to find, and change
your build procedure accordingly. You may want to use both of them, and to do that
you need to give them different DLL names, using the -soname option when you build
those DLLs.
1280 Can't open obey file <filename>.
Cause. You used the -obey option, but eld could not open the filename you specified.
Effect. Fatal error (eld immediately stops without creating an output file).
Recovery. Check that you really intended to specify a file of the indicated name, that
you spelled it correctly, and that you do have permission to read it.
1281 Unmatched double quotes in obey file.
Cause. You used the -obey option, and eld was reading that obey file, and eld found
a quotation mark (double quote character) within that obey file, either at the beginning
of a line or after white space in the middle of a line. eld assumes that a token begins
eld Manual—527255-009
6-42
Error Messages