Water Tank Removal - Hoshizaki Serenity Series KMS-1401MLJ Instruction Manual

2. Water Tank Removal

1) Remove the 2 thumbscrews securing the splash curtain, then remove the splash
curtain. See Fig. 7.
2) Disconnect the pump suction hose, drain pipe, and float connection hose at the
evaporator case wall. Disconnect the water tank drain hose from the bottom of the
water tank. Although the water tank can be removed at this point, do not remove it yet
because the bin control is taped inside the water tank.
The bin control cable is routed through the back of the icemaker. If care is not taken
when removing the water tank, the bin control cable could be severed.
Splash Curtain
Water Tank
Fig. 7
3) Pull out the water tank only as far as shown in Fig. 8.
4) Remove the cube guide, then remove the bin control assembly.
5) Being careful not to pull the bin control cable, remove the water tank completely
from the icemaker.
6) Remove the remaining pieces of tape from the water tank and leave the water tank out
of the icemaker for now.
Bin Control Cable
Cube Guide
NOTICE
Thumbscrews
Pump Suction Hose
17
Water Tank
Float Connection Hose
Drain Hose
Fig. 8
Evaporator
Case Wall
Drain
Pipe