Installation - Haier HWD–C1000TXVE ME User Manual

06

INSTALLATIoN

ADjUSTINg THE boTToM CoVER
before removing the transportation bolts, please fix the
bottom cover to the bottom of the washer dryer . Lay down
the machine (fig . 1 . ) , screw off the feet and adjust the
bottom cover with the four holes corresponding the screw
holes of the feet . Then screw the feet back on through the
cover and fix it thus securely to the bottom of the machine
(fig . 2 .) .
It keeps out the dampness and reduces the noise .
DISMANTLE THE TRANSPoRTATIoN boLTS
The transportation bolts are designed for clamping anti-
vibration components inside of the washer dryer during the
transportation process .
1 . Remove the back cover .
2 . Remove the three bolts on the rear side and take out
the synthetic stabilisers from within the machine .
3 . Replace the back cover .
4 . fill the holes left by the bolts with blanking plugs .
Note: keep the transportation bolts and syn-
thetic stabilisers in a safe place for later use .
ADjUSTINg THE WASHER DRYER
There are adjustable feet under the bottom of the washer dryer . before use, they
should be adjusted so that the machine is level . This will minimise vibrations and
thus noise during use . It will also reduce wear and tear . We recommend using a
spirit level to level the appliance .
bEfoRE USE
1 .
1 .
3 .
2 .
2 .
4 .