Haier HWD–C1000TXVE ME User Manual page 7

INLET HoSE
1 . Connect the nut on the inlet hose to the connector on
the water valve .
2 . Apply inlet hose to a water tab with cold, fresh water .
Note: Use the hose-set supplied with the appli-
ance . old hose-sets should not be reused .
DRAIN HoSE
1 . Use the drain hose bracket to keep the end of the
drain hose retained and prevent the outflow of water .
Don't extend the length of the drain hose; if an ex-
tended hose is required, please consult a serviceman .
2 . The height of the drainage outlet must be 80-100 cm .
fix the drain hose to the clip at the back of the wash-
ing machine to prevent it from dropping off .
Note: The drain hose should not be submerged in
water and should be securely fixed and leak-free . If the
drain hose is placed on the ground or if the pipe is at
a height of less than 80cm, the washing machine will
continuously drain while being filled (self-siphoning) .
CoNNECTINg To THE PoWER SUPPLY
before connecting to the power supply, check:
¬ The socket is adequate for the maximum power of the Washer Dryer
(for safety, fuses in the power circuit should be rated for no less than 15A) .
¬ The voltage should meet the requirement .
¬ The power outlet should be capable of accepting the Washer Dryer plug .
¬ Connect the machine to an earthed socket outlet .
bEfoRE USE
1 .
1 .
07
2 .
2 .