Installation - Haier HWD8040BW1 User Manual

Installation

Preparation
Remove all packaging material including polystyrene
base. While opening the package , water drops may be
seen on plastic bag and porthol e. This is normal as a
result from water tests and quality control in the factory.
Note: Packaging disposal:
Keep all packaging material out of children's reach and
dispose them in an e nvironmentally friendly manner.
OPTIONAL: Install noise reduction pads
2.
1.
1.When opening the shrink package,you will find four
noise reduction pads.These are used for reducing
noise.(Fig. 1)
2. Lay the washing machine down to its side, port-
hole pointing upwards, bottom side towards op-
3.
erator.（Fig.2）
3. Take out the noise reduction pads and remove the
double-sided adhesive protective film； Paste around
the bottom ； The noise reduction pads under the
washing machine cabinet as shown in Fig3.(two
longer pads in position 1 and 3, two shorter pads in
position 2 and 4). Finally set the machine upright again.
Removing the transportation bolts
The transportation bolts a re designed for clamping
antivibration components inside the appliance during
transportation.
1. Remove all 4 bolts.
General information and tips:
Keep the transportation bolts in a safe place for later
use. If the machine is to be moved to another location,
replace transportation bolts to prevent damage.
2. Fill the transportation bolt holes with blanking plugs.
8 9
3. Adjust all feets to achieve a complete level
position.This will minimize vibrations and noise
during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment. Floor
should be as stable and flat as possible.
Inlet hose
1. Connect inlet hose to the machine of water inlet valve.
2. Connect inlet hose to a water tap.
3. Tighten inlet hose connections and turn on water
supply. Check for any water leaks. Stop all water
leaks before continuing with in stallation.
Warning!
Appliance is only qualified for cold water supply!
Drain hose
Drainage could be installed in dif ferent ways.
Regardless of d rain hose has to reach between
80-100 cm.
If possible always keep drain hose fixed to the clip at
the back of the appliance.
1. Drain hose to sink
Use the drain hose bracket to keep drain hose end
retained and out of any water level.
Fix the bracket securely to avoid dropping due to oper-
ational movements.
2. Drain hose to sink siphon
Connection has to be securely sealed and fixed to corr-
esponding adapter above the siphoning part!
Warning!
The drain hose should not be submerged in water and
should be securely fixed and leak-free. If the drain hose
is placed on the ground or if the pipe is at a height of
less than 80 cm, the washing machine will continuously
drain while being filled (self-siphoning).
Install ation
80 - 100 cm