Preparation - Fujitsu ASU9C1 Operating Manual

PREPARATION

Turn on the Power
In the case of a direct line connection, turn on the circuit
breaker.
Load Batteries (AAA x 2)
1
Press and slide the battery compartment lid on the reverse
side to open it.
Slide in the direction of the arrow while pressing the
2
Insert batteries.
Be sure to align the battery polarities (ª/·) correctly.
3
Close the battery compartment lid.
Set the Current Time
1
Press the TIME ADJUST button (Fig. 7 ¢).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the /
to adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed
in one-minute steps; hold the buttons depressed to change the time quickly
in ten-minute steps).
3
Press the TIME ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
÷ The Remote Control Unit must be pointed at signal receiver (Fig. 1 3) to operate
correctly.
÷ Operating Range: About 7 meters.
÷ When a signal is properly received by the air conditioner, a beep be heard.
÷ If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
Insert
Press in
Screws
1 Mount the Holder. 2 Set the Remote Control
SET TEMP. SET TIME buttons (Fig. 6 ()
Pull out
3 To remove the Remote
Unit.
÷ Take care to prevent infants from
÷ When not using the remote control unit for
ON
÷ If leaking battery fluid comes in contact with
÷ Dead batteries should be removed quickly
mark.
÷ Do not attempt to recharge dry batteries.
Slide up
Control Unit.
CAUTION!
accidentally swallowing batteries.
an extended period, remove the batteries
to avoid possible leakage and damage to
the unit.
your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
and disposed of properly, either by placing
in a public battery collection receptacle, or
by returning to appropriate authority.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year under
normal use. If the remote control unit's
operating range becomes appreciably
reduced, replace the batteries and press
the ACL button (Fig. 7 ∞) with the tip of a
ballpoint pen or other small object.
En-6