Name Of Parts - Fujitsu Inverter Halcyon ASU24RLXQ Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
G
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
G
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
G
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
G
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 14 Auto Restart).
7 AIR CLEAN Indicator Lamp (orange)
8 Intake Grille (Fig. 4)
9 Front Panel
0 Air Filter
A Air Flow Direction Louver
B Power Diffuser
C Right-Left Louver
(behind Air Flow Direction Louver)
D Drain Hose
E Electrical Air Cleaning Filter
Fig. 5 Outdoor Unit
F Intake Port
G Outlet Port
H Pipe Unit
I Drain port (bottom)
G Refer to the folded out page on the cover.
En-3
Fig. 6 Remote Control Unit
J SLEEP button
K MASTER CONTROL button
L AIR CLEAN button
M SET TEMP. button (
N COIL DRY button
O Signal Transmitter
P TIMER MODE button
Q TIMER SET (
/
R FAN CONTROL button
S START/STOP button
T SET button (Vertical)
U SET button (Horizontal)
V SWING button
W RESET button
X TEST RUN button
G This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner's thermostat function to op-
erate incorrectly.
G If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit's OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
G To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Y CLOCK ADJUST button
Z Remote Control Unit Display (Fig. 7)
[ Transmit Indicator
\ Clock Display
] Operating Mode Display
_ Timer Mode Display
a Fan Speed Display
b Temperature SET Display
c AIR CLEAN Display
d COIL DRY Display
e SLEEP Display
f SWING Display
/ )
) button