CR-4000 SERIES CASH DRAWER USER’S MANUAL Rev. : C NOTICE The manufacturer of the POS cash drawer makes no representation or warranties, either expressed or implied, by or with respect to anything in this manual, and shall not be liable for any implied warranties of fitness for a particular purpose or for any indirect, special or consequential damages.
MODEL NUMBERS Model CR400X CR410X CR421X 5 Adjustable 5 Fixed 5 Fixed Bill Compartment Plastic Metal Metal Bill clip 9 Fixed 9 Fixed 5 Fixed Coin compartment 1Underneath Cash Tray 4 Behind Cash Tray Coin Roll storage INFERFACE APPLICATION Security Model Number Interface Power / Source...
b). For CR4001/ 4101/ 4211/ 4002/ 4102/ 4212: CCBLA-196A with one 9PM and one 9PF connector. c). For CR4003/ 4103/ 4213: CCBLA-089-1 with one 25PM and one 25PF connector. d). For CR4004/ 4104/ 4214: The serial signal cable is already built on. e).
3). Set S1 for security code to open cash drawer. In normal practice, the security code is suggested to be a non-displayable ASCII character. For. example, a hexadecimal number between 01 to 1F. Please refer to rear panel illustration below. CR4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213 Rear panel illustration.
COM1 616P PHONE JACK 4PIN PHONE JACK CR4005/ 4105/ 4215/ CR4005-II/ 4105-II/ 4215-II 1). Define a drawer number for the cash drawer so that this cash drawer is going to respond accordingly in USB communication. Follow the table below for SWITCH SETTING to adjust the switch S1 according to this drawer number if it is not 7.
UPOS driver application (Applied for all Posiflex cash drawer) Please first find in Posiflex Product Information CDROM or download from Posiflex web sites for UPOS driver setup. In this application CR4XX3 and CR4XX4 respond to openDrawer command only; CR4XX0, CR4XX1 and CR4XX2 are compliant to UPOS version 1.4;...
2. Start up the test program and click “STATUS” button. The drawer status of Open/Close or Not present will be displayed under each drawer number as “O”, “C” or “N” 3. Use a key to turn the lock to standby position (the one marked with sign at middle), click the check only the box (es) under the drawer number(s) for the drawer(s) to be tested then click the “KICK”...
Security Code CR-4002/ 4102/ 4212/ 4003/ 4103/ 4213 1-255; factory preset value = 7 CR-4005/ 4105/ 4215/ 4005-II/ 4105-II/ 4215-II USB PID Drawer Open Sense CR-4000/ 4100/ 4210 Drawer open sense circuit shorts when open CR-4001/ 4101/ 4211/ 4002/ 4102/ 4212 Pin 9 shorts to pin 5 when drawer open CR-4005/4105/4215/4005-II/4105-II/4215-II Through USB driver KEYLOCK OPERATION...
Need help?
Do you have a question about the CR-4000 SERIES and is the answer not in the manual?
Questions and answers