CR-4000 SERIES CASH DRAWER USER’S MANUAL Rev. : C NOTICE The manufacturer of the POS cash drawer makes no representation or warranties, either expressed or implied, by or with respect to anything in this manual, and shall not be liable for any implied warranties of fitness for a particular purpose or for any indirect, special or consequential damages.
MODEL NUMBERS Model Bill Compartment Bill clip Coin compartment Coin Roll storage INFERFACE APPLICATION Model Number CR-4000/4100/4210 CR-4001/4101/4211 CR-4002/4102/4212 CR-4003/4103/4213 CR-4004/4104/4214 CR-4005/4105/4215 CR-4005-II/4105-II/4215-II USB CARTON CONTENTS Cash drawer pre-assembled. User’s manual. Separators of bill compartment: 4 pcs (for CR4000~5 and CR4005-II only). Key 2pcs: There is a key serial No.
b). For CR4001/ 4101/ 4211/ 4002/ 4102/ 4212: CCBLA-196A with one 9PM and one 9PF connector. c). For CR4003/ 4103/ 4213: CCBLA-089-1 with one 25PM and one 25PF connector. d). For CR4004/ 4104/ 4214: The serial signal cable is already built on. e).
3). Set S1 for security code to open cash drawer. In normal practic e, the security code is suggested to be a non-displayable ASCII character. For. example, a hexadecimal number between 01 to 1F. Please refer to rear panel illustration below. CR4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213 Rear panel illustration.
4PIN PHONE JACK CR4005/ 4105/ 4215/ CR4005-II/ 4105-II/ 4215-II 1). Define a drawer number for the cash drawer so that this cash drawer is going to respond accordingly in USB communication. Follow the table below for SWITCH SETTING to adjust the switch S1 according to this drawer number if it is not 7. Please note that within each system there should never be any 2 USB interface cash drawers carrying the same drawer number.
UPOS driver application (Applied for all Posiflex cash drawer) Please first find in Posiflex Product Information CDROM or download from Posiflex web sites for UPOS driver setup. In this application CR4XX3 and CR4XX4 respond to openDrawer command only; CR4XX0, CR4XX1 and CR4XX2 are compliant to UPOS version 1.4;...
2. Start up the test program and click “STATUS” button. The drawer status of Open/Close or Not present will be displayed under each drawer number as “O”, “C” or “N” 3. Use a key to turn the lock to standby position (the one marked with sign at middle), click the check only the box (es) under the drawer number(s) for the drawer(s) to be tested then click the “KICK”...
Need help?
Do you have a question about the Cash Drawer CR400X and is the answer not in the manual?
Questions and answers