Manual Auto Operation - Friedrich MW18C3F Operating Manual

SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 S).
The SWING Display (Fig. 7 a) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the
air flow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 6 S) once again.
The SWING Display (Fig. 7 a) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
During cooling/Dry mode : Swings between 1 and 3.
During fan mode
G The SWING operation may stop temporarily when the air conditioner's fan is not
operating, or when operating at very low speeds.

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main unit
control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) once again.
(Controls are located inside the Open Panel)
06B030_9315255044-01_En
: • Air flow Direction setting 1,2,3.
Swings between 1 and 3.
• Air flow Direction setting 4,5,6,7.
Swings between 3 and 7.
10
G When the air conditioner is operated
with the controls on the Main Unit, it
will operate under the same mode as
the AUTO mode selected on the Re-
mote Control Unit (see page 6).
G The fan speed selected will be "AUTO"
and the thermostat setting will be
°F
standard.(76 )
2006.3.7, 4:11 PM
En-10