Maintenance; Warranty Statement - Worx WG113 Instruction Manual

A
'clattering' noise will be heard for a short
time. This is normal and is caused by the line
being cut by the line cutter. Once the line is
cut to the correct length, the 'clattering' noise
will stop and the trimmer motor will run at full
speed.
To feed more line, stop the trimmer
completely, then restart, allowing the motor
to reach full speed. Repeat this until you hear
the 'clattering' noise of the line cutting. (Do not
repeat this procedure more than 6 times)
TO MANUALLY FEED THE LINE (See H)
While gently pulling on the line, press and
release the manual feed button (16). Repeat
until the line has reached the line cutter. Pull
the second line out in the same manner. If the
line extends past the line cutter, too much line
has been fed out.
Iftoo much line is fed out, remove the spool
cap and click the spool counter-clockwise until
the line is at the desired length.
Rs:MGV|NG THE CAP
Press and hold in the two latches (12) (See J).
le Pull cap away from the spool holder. Keep
the cap and spool holder clean from debris.
To replace the cap, press it firmly towards
the spool holder. Ensure that it is correctly
connected by trying to remove it without
depressing the two latches.
CHANG|N6 THE LINE SPOOL:
First take off the cap and remove the old spool.
Place new spool into cutting head. Feed one
line through the eyelet, then repeat for second
line. Release secured line from the cleat if
needed.Reattach the cap.
_ ARMNG!YourTrimmer is designed
to only use line with a maximum
diameter of 0.065". Only use nylon line.
IMPORTANT _ Always wind the line onto
the upper section of the spool first.
TO MANUALLY WIND LINE
Take approximately 16ft line and insert 5/8" of
line into one ofthe holes in the upper section
ofthe spool. Wind the line in the direction of
the arrows on the top of the spool.
Leave approximately 4" of line unwound and
place it into the cleat. Repeat on the lower
section of spool.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit the spool as described above in
"Changing the Une Spool".
MAINTENANCE
After use, disconnect the machine from
the power supply and check for damage.
Your power tool requires no additional
lubrication or maintenance.There are no user
serviceable parts in your power tool. Electric
trimmers should only be repaired by an
authorised repairer. Use only manufacturers
recommended replacement parts and
accessories.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
place out of the reach of children. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your power tool.
WARRANTY STATEMENT
30 DAY Satisfaction Guarantee
If for any reason you are dissatisfied with any
WORX product, you can return the product
along with proof of purchase within 30 days
for a full refund.
If yourWORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of;
.24 months for DIYand light trade use, from
the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
to fair wear and tear, free of charge, or at our
discretion, replace the unit free of charge
to ensure minimum inconvenience to the