Power Modes
The Network Display has three modes of operation.
The following assumes the AC Power Adapter is connected to the display and an AC power source.
Power Mode
1
Off
2
Run
3
Standby
Adjusting the Display
The monitor has four function control buttons designed for comfortable viewing and listening.
Function Description
Icon
Function
Brightness
Audio Volume
LED
•
Power button is pressed for 3 Sec while in Standby mode (Thin
client is switched off)
•
Power button is pressed for 3 Sec while in Run mode (Thin client
Dark
and display are switched off)
Caution: Be very careful to not turn off the Display while the operating
system is downloading a software update!
•
If the Power button is momentarily pressed when in the Off mode
the display is powered and the thin client will boot.
Green
•
If the Power button is momentarily pressed while in Standby
mode, the display returns to Run mode.
•
If the Power button is momentarily pressed while in Run mode the
Yellow
display is turned off while the Thin Client continues to operate.
This mode can be used for privacy or to conserve power.
The brightness of the display may be varied.
The volume of the speakers and headphone may be varied.
Figure 2-2
Operation Description
Function Description
8