Table of Contents
Advertisement
Assembly
Shaft Grip
_)
Bottom Clamp
{4)Nuts _®
i
Fig. 3-t
_
!
I
I
!
Fig. 3-2
On some units, the D-handle may be preinstalled and
only require loosening the screws and adjusting the
D-handle to the operator. Go to step 4 for adjusting the
D-handle if preinstalled.
INSTALLING
AND ADJUSTING
THE D-HANDLE
1.
Remove the screws, nuts and bottom clamp piece
that were installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto
the bottom clamp (Fig. 3-1). Place it a minimum of
6 inches (15.24 cm) from the end of the shaft grip.
,
Hold each hex nut in the bottom clamp recess with
a finger. Start screws with a large Phillips screw-
driver. Do not tighten until you make the handle
adjustment.
4.
If it was preinstalled, loosen the screws on the
D-handle just enough to move the D-handle.
5. While holding the unit in the operating position
(Fig. 3-2), position the D-handle to the location
that provides you the best grip.
6. Tighten the clamp screws evenly, until the D-handle
is secure.
Advertisement
Table of Contents
