Pioneer PRV-LX1 Maintenance page 3

Hide thumbs Also See for PRV-LX1:

To determine when to replace versus clean filters, refer to the following chart:

Clean The Filters

grime on filter cover can be wiped away

visible dirt on the filter is removable with

a small vacuuming device

(available commercially)

The replacement filter (P/N DEC2530) is available from the Pioneer Electronic Service organization.

The replacement part DEC2530 consists of a single filter. Replace both front filters at the same time

to keep the PRV-LX1 at top performance. Follow the directions below to replace a filter.

1. Confirm that the PRV-LX1 is in Standby (indicator light is orange).

If the PRV-LX1 is not in Standby, stop any current operation then press and hold the

STANDBY/ON button for at least two seconds to place the recorder in Standby.

2. Turn the main power off.

Set the rear power switch to OFF.

Disconnect the power plug from the outlet.

4. Slide a front filter cover down while pulling the bottom edge slightly away to remove it.

Do not discard this cover as it is reused.

Pioneer Electronics (USA) Inc.

Home & Business Group of America

http://parts.pioneerelectronics.com

or call (800) 228-7221 for the Parts Department

(800) 872-4159

Replace the Filters (Part # DEC2530)

cover or filter feels greasy to the touch

any dirt or debris remains after wiping the

cover or vacuuming the filter

TIB #190112

Released: Aug-2007

Page 3 of 5