Hitachi L26D205 Owner's Manual page 35

Connections to other equipment
Using an AV Amplifier with built-in digital surround
If you are using an AV Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital
Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as shown below.
Rear of the unit
To DIGITAL AUDIO
COAXIAL OUT
Coaxial digital cable
(not supplied)
Digital Audio Input
AV Amplifier with built-in digital surround
decoder as listed above
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
To connect the unit to a PC (Personal Computer)
Before you connect this unit to your PC, change the adjustment of your PC's Resolution and Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR
IN on the rear of the unit. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio
cord to the audio output of your Multimedia computer and to the AUDIO IN connector of the PC/DVI AUDIO IN jack of the unit.
You can also connect the PC with HDMI cable. If you use HDMI cable, you don't have to connect the audio cord. If you use DVI-to-HDMI
cable, please connect the audio cord in the same way as the VGA cable.
Press INPUT on the remote control to select PC mode.
Switch on the computer. The unit can operate as the computer monitor.
Rear and left of the unit
To HDMI1/
DVI IN
To PC/DVI
AUDIO IN
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
56P5021A_eng.indd 35 56P5021A_eng.indd 35
To Coaxial
To PC
MONITOR IN
VGA cable
(not supplied)
Audio cord
(not supplied)
HDMI cable (not supplied)
TV/DVD
Front
Speaker
(Left)
Surround
Speaker (Left)
To return to normal mode
Press INPUT again.
(continued)
Front
Speaker
Subwoofer
(Right)
Center Speaker
Surround
Speaker
(Right)
Monitor Display modes
Mode Resolution Refresh rate
VGA 640x480 60/ 72/ 75 Hz
VGA 720x400 70Hz
SVGA 800x600 56/ 60/ 72/ 75 Hz
XGA 1024x768 60/ 70/ 75 Hz
WXGA 1280x768 60Hz
WXGA 1280x720 60Hz
WXGA 1360x768 60Hz
35
5/21/11 3:22:08 PM 5/21/11 3:22:08 PM