Advertisement
ASSEMBLY
Base Wire
Red
Mark
Footrest
2
Wire
Soothing
Unit
• Position the footrest wire so that the soothing unit is upright.
• While flexing the base wires toward each other, hook the footrest wire
onto the ends of the base wires.
• Push the footrest wire down completely, below the red marks on the
base wires.
3
• Position the seat back wire with the toy bar sockets upright.
• Fit the seat back wire completely onto the base wires, so that each end
covers the red mark on each base wire.
• Make sure the plastic covers on the seat back wire cover the red
marks on the base wire.
Red Mark
Base Wire
Seat Back
Wire
Toy Bar
Socket
Red
Plastic
Mark
Cover
Base
Wire
5
ASSEMBLY
4
Plastic
Cover
Protruding Side
• Fit the nut (so that the protruding side is
outward) into the hexagonal opening on
#8 x 32 Nut
the inside of each plastic cover.
• Insert a screw through the outside of each plastic cover and tighten with a
Phillips screwdriver. Do not over-tighten.
• Pull up on the seat back wire to be sure it is secure. If you can remove
either end of the seat back wire, you have not assembled it correctly.
Remove the screws, re-read and repeat Assembly steps 3 and 4.
Pull Up
6
Advertisement
