Download Print this page

Fisher-Price 79008 User Manual

Sounds 'n lights deluxe soothing bouncer

Advertisement

Quick Links

SOUNDS 'N LIGHTS DELUXE
SOOTHING BOUNCER
Model Number: 79008
Please save these instructions for future reference.
Tool needed for adult assembly:
Phillips screwdriver (not included).
Requires one, size "D" (LR20) alkaline battery (not included) in the soothing unit.
Requires three, size "AA" (LR6) alkaline batteries (not included) in the toy bar.
Slide switch to
mirror for sounds
or
AND bat
and lights!
WARNINGS
WARNING
To prevent serious injury and/or falls:
• Never use on any elevated surface.
• Never use as a carrier or lift while
child is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use with a child able to sit
up unassisted.

CONSUMER INFORMATION

Occasionally a consumer may experience
a problem with one of our products.
If this should happen, please call us toll-free,
rather than return this product to the store.
Usually, we can solve the problem over the telephone
or send you replacement parts.
Please call Fisher-Price
®
Consumer Affairs,
toll-free at 1-800-432-KIDS,
between 8 AM - 5 PM EST, Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.
Or write to:
Fisher-Price® Consumer Affairs
636 Girard Avenue
East Aurora, New York 14052.
2

Advertisement

loading

Summary of Contents for Fisher-Price 79008

  • Page 1: Consumer Information

    SOUNDS 'N LIGHTS DELUXE SOOTHING BOUNCER Model Number: 79008 Please save these instructions for future reference. Tool needed for adult assembly: Phillips screwdriver (not included). Requires one, size “D” (LR20) alkaline battery (not included) in the soothing unit. Requires three, size “AA” (LR6) alkaline batteries (not included) in the toy bar.
  • Page 2 PARTS Toy Bar 2 Paddles 2 Flowers Butterfly Footrest Wire Right Base Wire Base Connector #8 - 32 x " Screw - 2 Shown Actual Size Shown Actual Size Seatback Wire • Place the base connector on a flat surface as shown. •...
  • Page 3 ASSEMBLY Base Wire Mark Footrest Red Mark Wire Soothing Unit • Position the footrest wire so that the soothing unit is upright. • While flexing the base wires toward each other, hook the footrest wire onto the ends of the base wires. •...
  • Page 4 ASSEMBLY Restraint Belt • Position the pad with the ruffle upright. • Fit the upper pocket on the back of the pad onto the seat back wire • Fit the restraint belts through the slots in the pad • Lift the footrest wire. Fit the lower pocket on the back of the pad onto the footrest wire .
  • Page 5: Battery Installation

    ASSEMBLY Toy Bar Wire Paddle Paddle Plugs Flowers Sockets Butterfly • Fit the toy bar plugs into the socket in each plastic cover. • Snap the paddles to the toy bar wire. • Fit the tab on the butterfly into the slot in the paddle.
  • Page 6: Setup And Use

    BATTERY INSTALLATION – 1.5V x 3 “AA” (LR6) SHOWN ACTUAL SIZE Toy Bar • Locate the battery compartment door on the back side of the toy bar. • Loosen the screw in the battery compartment door with a Phillips screwdriver and lift to remove the door.
  • Page 7 SET-UP & USE Anchored End Anchored End Buckle Free End Tighten To tighten the restraint: • Feed the anchored end of the restraint strap up through the buckle to form a loop • Pull the free end of the restraint strap •...
  • Page 8: Fcc Note (United States Only)

    • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©1999 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.