Advertisement
Problem
You hear static or buzzing
Receiver power/low battery indicator
does not light
Receiver power/low battery indicator
turns orange
Transmitter power indicator does
not light
You can hear conversations or sounds
from other homes
Hint: If, after checking all of these solutions, you believe that your transmitter power cord or AC adaptor are damaged,
please contact Mattel.
G Problems & Solutions
Receiver is out of range of transmitter. Move receiver closer to transmitter.
Note: Range varies depending on surrounding conditions such as noise
levels, physical obstructions and signal interference.
Transmitter power is off. Turn transmitter power on.
Channel switches are on different channels. Make sure channel switches on
both transmitter and receiver are set to same channel.
Loose power cord connection and transmitter power is off. Check transmitter
power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure light switch
that controls power fl ow to wall outlet is on.
Power is off because circuit breaker for room is off. Make sure house fuses
and circuit breakers are on.
Receiver power is off. Turn receiver power on.
Batteries in receiver are weak or dead. Replace all batteries with three,
alkaline "AAA" (LR03) batteries or use AC adaptor as power source.
Power is off because circuit breaker for room is off. Make sure house fuses
and circuit breakers are on.
No power to wall outlet and power is off. Make sure light switch that
controls power fl ow to wall outlet is on.
Batteries in receiver are weak or dead. Replace all batteries with three,
alkaline "AAA" (LR03) batteries or use AC adaptor as power source.
Transmitter power is off. Turn transmitter power on.
Loose power cord connection and transmitter power is off. Check transmitter
power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure light switch
that controls power fl ow to wall outlet is on.
Power is off because circuit breaker for baby's room is off. Make sure house
fuses and circuit breakers are on.
There is signal interference due to other nursery monitors on same channel
or cordless telephone use. Change channel switches on both transmitter
and receiver to eliminate source of interference.
21
Solution
Advertisement
