Reverse Door Swing (Optional) - Amana W10150612B Installation Instructions Manual

You can change your door swing from a right-side opening to a
left-side opening, if desired.
Reversible Large Side-Swing Door
D
1. Place towel (A) on top of dryer to protect surface.
2. Open dryer door. Remove bottom screws from cabinet side of
hinges (C). Loosen (do not remove) top screws from cabinet
side of hinges.
3. Lift door until top screws in cabinet are in large part of hinge
slot. Pull door forward off screws. Set door on top of dryer.
Remove top screws from cabinet.
4. Use a small, flat-blade screwdriver to gently remove 4 hinge
hole plugs (D) on left side of cabinet. Insert plugs into hinge
holes on right-hand side of cabinet.
5. Insert screws into bottom holes on left side of cabinet. Tighten
screws halfway. Position door so large end of door hinge slot
is over screws. Slide door up so screws are in bottom of slots.
Tighten screws. Insert and tighten top screws in hinges.
6. Close door and check that door strike aligns with door catch
(B). If needed, slide door catch left or right within slot to adjust
alignment.
Reversible Super Wide Side-Swing Door
E
F
1. Place towel (A) on top of dryer to protect surface.
2. Open dryer door. Remove bottom screws from cabinet side of
hinges (D). Loosen (do not remove) top screws from cabinet
side of hinges.
14

Reverse Door Swing (Optional)

3. Lift door until top screws in cabinet are in large part of hinge
4. Remove screws attaching hinges to door.
5. Remove screws at top, bottom and side of door (4 screws).
A
6. Be certain to keep cardboard spacer centered between doors.
B
C
7. Attach door hinges to dryer door so that the larger hole is at
8. Remove door strike (E) from cabinet. Use a small, flat-blade
9. Insert screws into bottom holes on left side of cabinet. Tighten
10. Remove door strike plug (B). Insert the door strike you
A
11. Close door and check that door strike aligns with door catch
B
C
D
slot. Pull door forward off screws. Set door (handle side up) on
top of dryer. Remove top screws from cabinet.
Holding door over towel on dryer, grasp sides of outer door
and gently lift to separate it from inner door. Do not pry apart
with putty knife. Do not pull on door seal or plastic door
catches.
Reattach outer door panel to inner door panel so handle is on
the side where hinges were just removed.
the bottom of the hinge.
screwdriver to gently remove 4 hinge hole plugs (F) on left side
of cabinet. Insert plugs into hinge holes on right side of
cabinet.
screws halfway. Position door so large end of door hinge slot
is over screws. Slide door up so screws are in bottom of slots.
Tighten screws. Insert and tighten top screws in hinges.
removed in Step 8 into hole and secure with screw. Insert door
strike plug into original door strike hole and secure with screw.
(C). If it is needed, slide door catch left or right within slot to
adjust alignment.