Table of Contents
Advertisement
ASSEMBLY
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment knob securely.
SEAT PAN
SHOULDER
BOLT
FLATWASHER
ADJUSTMENT
KNOB
FIG. 2
CHECK
BATTERY
(See Fig, 3)
•
Lift seat pan to raised position.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
SEAT PAN /
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLLTRACTOR
OFF
SKID
(See
Op-
eration
section
for location
and function
of
controls)
Press lift lever plunger and raise attachment
lift lever
to its highest position.
•
Release parking
brake by depressing
clutch/brake
pedal.
•
Place gearshift lever in neutral (N) position.
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
TO DRIVE
TRACTOR
OFF SKID
(See
Op-
eration
section
for location
and function
of
controls)
&(_WARNING: Befora starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place gear shift lever in neutral (N) position.
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Start the engine.Afterengine
has started, move throttle
control to idle position.
•
Depress clutch/brake pedal into full "BRAKE" position
and hold. Move gearshift lever to 1st gear.
•
Slowly release clutch/brake pedal and slowly drive
tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
gearshift lever in neutral position.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
ASSEMBLE
GAUGE
WHEELS
TO
MOWER
DECK
(See Fig. 4A)
The gauge wheels are designed to keep the mower deck
in proper position when operating mower. Be sure they are
properly adjusted to ensure optimum mower pedmance.
•
Slide gauge wheel bar down into bracket channel, Be
sure that gauge wheel bar aligning holes are on top.
Assemble gauge wheels as shownusing shoulderbolts,
3/8 washers and 3/8-16 center Iocknuts and tighten
securely.
•
Adjust gauge wheels before operating mower.See"TO
ADJUST GAUGE WHEELS" in the Operation section
of this manual.
RETAINER SPRING
PIN_<_,_
SHOUL-
DER BOLT
ADJUSTING
RAR
WHEEL
3/SWASHER
_16
CENTER
LOCKNUT
FIG. 4A
7
Advertisement
Table of Contents
