Table of Contents
Advertisement
ASSEMBLY / PRE-OPERATION
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod has the long loop on the end
of the spring as shown.
1.
Slide rubber sleeve up rod and hook end of spring into
pivot bracket with loop opening down as shown.
2.
With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into hole
in drive control bracket. Secure with retainer spring.
TRACTION
DRIVE
CONTROL ROD
RUBBER
SLEEVE
PIVOT
BRACKET
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod has the short loop on the end of the
spring as shown.
1.
Slide rubber sleeve up rod and hook end of spring into
control arm with loop opening up as shown.
2.
With top end of rod positioned under rightside of control
panel, push down on rod and insert end of rod into hole
in auger control bracket. Secure with retainer spring.
CONTROL
ARM
AUGER
s'
;'-
'
;'q
2
;_- ,2
, _1
{_ :ii{_ ;1
,_- ,s
, - s i
FIG. 3
TRACTION
DRIVE
CONTROL
LEVER
RETAINER
SPRING
CONTROL
BRACKET
FIG. 4
FIG. 5
AUGER
CONTROL
ROD
RETAINER
SPRING
AUGER
CONTROL
LEVER
CONTROL
BRACKET
FIG. 6
6
Advertisement
Table of Contents
