Poulan Pro PP325 Instruction Manual page 5

_X" Handlebar _ Screw
t
__Cover
Mounting _" _
Bracket "_
ASSEMBLY OF SHOULDER STRAP
_WARNING:
Proper shoulder strap
and handlebar adjustments must be made
with the engine completely stopped before
using unit.
1. Insert your right arm and head through
the shoulder strap and allow it to rest on
your left shoulder. Make sure the danger
sign is on your back and the hook is to the
right side of your waist.
NOTE: A one-half twist is built in the shouF
der strap to allow the strap to rest flat on the
shoulder.
2. Adjust the strap, allowing the hook to be
about 6 inches (15 cm) below the waist.
3. Fasten the strap hook to the clamp located
between the trigger handle and the handle-
bar clamp base and lift the tool to the oper-
ating position.
4. Try on shoulder strap and adjust for fit
and balance before starting the engine or
beginning a cutting operation.
NOTE: It may be necessary to relocate the
shoulder strap clamp on the shaft for proper
balancing of unit.
TO RELOCATE SHOULDER STRAP
CLAMP:
1. Loosen and remove both clamp screws.
2. Place the upper shoulder strap clamp
over the shaft=
3. Position the lower shoulder strap clamp
under the shaft and align the upper and
lower clamp screw holes.
Strap Clamp
Lower Shoulder J
Strap Clamp I Screws
4. Insert two screws into the screw holes.
5. Secure shoulder strap clamp by tighten-
ing screws with a hex wrench.
HARNESS
ADJUSTMENT
FOR BALANCE
6 inches 4 - 12 inches
(15 cm) (10 - 30 cm)
below above
waist ground
30 inches
(76 cm)
CONFIGURING YOUR UNIT
You can configure your unit using a cutting head
for grass and light weeds, or a weed blade for
cutting grass, weeds, and brush up to t/2 inch
(1 cm) in diameter. To assemble your unit. go to
the section for the desired configuration and fol-
low the instructions.
ASSEMBLY INFORMATION -
TRIMMER HEAD
_TRIMMER
NOTE: Remove the blade and metal shield be-
fore attaching the plastic shield and trimmer
head. To remove blade, align hote in the dust
cup with the hole in the side of the gearbox by
rotating the blade, insert a small screwdriver
into aligned holes. This will keep the shaft from
turning while loosening the blade nut. Remove
blade nut by turning clockwise. Remove the
screwdriver. Remove both washers and blade.
To remove metal shield, loosen and remove the
four mounting screws. See Aqq-ACHING THE
5