If you purchasethe optiona!chestputsesensor(seepage22},followthe stepsbelowto installthe re-
ceiverandthe shortjumperwireincludedwith the chestputsesensor.
1, Makesurethatthepowercordis unplugged. R emove
theindicated s crews fromtheConsobBack (88),
(Important: T hescrewsmaybedifferentlengths;
makesureto remember t he odgina!tocationof each
screw.}Next,remove t heConsobBack,
88
Screws
2, Peel t hepaperoffthepadonthebottom of thereceiver
(A),Turnthe receiverso the smallcylinderis on the
sideshown,andpressthereceiver i ntotheConsole
Base(81)intheindicated location,
%
Cylinder
3, Connect the included short jumper wire (B) to the wire on
the receiver (A), Connect the other end of the short
jumper wire to the PLS2 jack on the underside of the
Console (82), (Note: if there is already a wire in the PLS2
jack, unplug it,) Discard the other wires included with the
receiver, Use the included wire tie to secure the wires, if
needed,
Make sure that no wires are pinched.
See step 1,
Rsattach the Console (82) with the screws, Important:
If
the screws are not reattached
in their original
loca-
tions, the Console
may be damaged.
82
PLS2
Jack