Page 1
MOWER " °°es 20112X92E0 20112X92E1 INSTRUCTION BOOK This Instruction Book contains information for several models. Read and keep this book for future reference. This book contains important information SAFETY, ASSEMBLY, OPERATION, MAINTENANCE & STORAGE. PRODUCT INFORMATION The owner must be certain...
Page 2
Maintenance ........12-14 Warranty ..........Safety Rules ......... Service and Adjustments ....... Product Specifications ......Storage ..........15-16 Assembly/Pre-Operation ...... Troubleshooting ........ 16-17 Operation ..........9-11 Repair Parts ........18-19 Maintenance Schedule ......Service ........Back Cover The Manufacturer warrants to the original consumer purchaser...
This instruction book is written for a person unit is correctly assembled. The owner must with some mechanical ability. Like most ser- carefully check the unit according to the in- structions in this manual before it is first used. vice books, not all the steps are described.
• See manufacturer'sinstructionsfor • Be alert and turn machine off if children proper operationand installationof enter the area. accessories.Only use accessoriesap- • Before and while walking backwards, proved by the manufacturer. look behind and down for small children. • Stop the blade(s)when crossing gravel •...
Page 5
Neverattemptto makewheel height • Mowerbladesare sharp and can cut. adjustmentswhile the engineis running. Wrap the blade(s)or wear gloves,and Grasscatchercomponentsare subjectto use extra caution when servicing them. wear, damage, and deterioration,which • Do not change the enginegovernorset- couldexposemovingpartsor allowobjects ting or overspeedthe engine. to be thrown.
Parts packed separately in carton Parts Bag Contents (not shown full size) Control (1) Rope Guide (1) Upper Handle (1) Lower Handle Cable (1) Upstop Bracket TOOLS REQUIRED FOR ASSEMBLY _:_CAUTION: Do not operate this mower A socket wrench set will make assembly without the discharge guard...
Page 7
1. Positionlower handleon housingso ASSEMBLE WHEELS cut-offflat is forwardas shown. Cutting height is determined by assem- 2. Align holes in handlewith holes in bling the wheels in one of four possible housingas shown and assemble3/8- positions on the mower housing. 16 x 3/4 hex bolts, flat washers,and wheels must be in the same height...
Page 8
INSTALL CONTROL Control bar Upper handle Position control bar so flattened sec- tion with hole is on opposite side of Up-stop handle as up-stop bracket. bracket Insert one end of control bar into handle hole on inside of handle. Care- fully push in on opposite end of control bar and insert into hole on opposite...
Page 9
KNOW YOUR LAWN MOWER READTHIS OWNER'S MANUALAND ALL SAFETY RULES BEFORE OPERATINGYOUR LAWN MOWER. Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your lawn mower or in literature supplied with the product.
BEFORE STARTING ENGINE The operationof any SAFE, GLASSES lawn mowercan result ADD OIL in foreign objectsthrown Your lawnmower is shipped without oil in into the eyes,which can the engine. For type and grade of oil to result in severeeye dam- use, see "ENGINE"...
Page 11
MOWING TIPS CAUTION: Alcohol blended fuels (called _, CAUTION: Do not use de-thatcher gasohol or using ethanol or methanol) attract moisture which leads to separation blade attachments on your mower. Such and formation of acids during storage. Acidic attachments are hazardous, will damage gas can damage the fuel system...
MAINTENANCE BEFORE AFTER EVERY EVERY EVERY BEFORE EACH EACH 25HOURS SCHEDULE HOURS OR SEASON HOURS STORAGE Check for Loose Fasteners Clean / Inspect Grass Catcher Check Tires Check Drive Wheels Clean Lawn Mower ..Clean under Drive Cover *** Check Drive Belt / Putleys *** Check / Sharpen / Replace Blade...
Page 13
LAWN MOWER Crankshaft Blade adapter Always observe safety rules when per- forming any maintenance. Lockwasher TIRES • Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber. • Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause...
Page 14
TO CHANGE ENGINE Screw ASSEMBLE ONE OF THESE LOW POINTS TOWARDS NARROW EDGE OF ELEMENT Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. Be sure lawn mower is on level sur- face.
Page 15
_WARNING: To avoid serious injury, before performing any service or adjustments: Release control bar and stop engine. Make sure the blade and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come contact with plug.
OTHER NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation • Do not store gasoline from one season to another. of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or • Replace your gasoline can if your can starts to rust.
Page 17
TROUBLESHOOTING - See appropriate section in manual unless directed to a qualified service center, PROBLEM CAUSE CORRECTION 1. Raise cutting height. Loss of power Rear of mower housing blade dragging in grass. Cutting too much grass. Raise cutting height. Dirty air filter. Clean/replace air filter.
Page 18
ROTARY LAWN MOWER - - MODEL NUMBER 20112X92E (20112X92E0, 20112X92E1)
PARTS AND SERVICE This product has been expertly engineered and carefully manufactured to rigid quality standards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. For Parts and Service, contact our authorized distributor: call 1-800-849-1297...
Need help?
Do you have a question about the 20112X92E1 and is the answer not in the manual?
Questions and answers