Fisher & Paykel 80078 Installation Instruction

CONTROL PANEL
LIGHT REPLACEMENT
a) Halogen bulb 12Volt/20Watt required.
b ) Switch off the power to rangehood.
c ) Use a small bladed screwdriver to prise off the light cover.
d ) Use a cloth to remove the bulb. Do not touch the bulb with fingers.
e ) Replace with a new bulb using a cloth. Do not touch the bulb
with fingers. Snap the cover back in place.
For other accessories, parts or service, please contact your local supplier (Refer to Warranty Certificate).
I N S T A L L A T I O N
DUCTED
UNIDUCT FLEXI DUCT KIT is recommended.
1569 Flexi Duct Kit (150mm)
For other accessories, parts or service, please contact your local supplier or approved service agent
MAINTENANCE
Particular care should be taken with grease filter which must be periodically cleaned (at least
every two months). Remove the grease filters and wash them either by hand or in the
dishwasher using mild detergent. Caution: Never use products containing abrasives
(e.g. scouring pads, steel wool, abrasive liquid cleaner etc.) Use lukewarm water and a mild
detergent to clean stainless steel components. In high humidity and coastal environments,
cleaning should be carried out more frequently.
WARNINGS
• Care should be taken when removing filters in order to prevent the filter falling and causing
damage to the hob top.
• This appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• Upon installation the appliance must be positioned so that the plug is accessible.
• There should be adequate ventilation of the room when the rangehood is used at the same time as
appliances burning gas or other fuels.
• You must read the details concerning the method and frequency of cleaning.
• There is a fire risk if cleaning is not carried out in accordance with the instructions.
• Do not flambé under the rangehood.
• Exhaust air must not be discharged into an existing flue used for exhausting fumes from
appliances burning gas or other fuels.
• The recomended minimum distance between the hob surface and the lowest part of the range-
hood is 600mm. This should be increased to at least 650mm if installed over a gas hob.
We recommend 700mm.
• Attention should be given to ensure that any applicable regulations concerning the discharge
of exhaust air is fulfilled.
• If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer
or it's service agent, or a similarly qualified person in order to avoid a hazard.
RECOMMENDED UNIDUCT DUCTING
6 ZELANIAN DRIVE, EAST TAMAKI
SYSTEMS FOR RANGEHOODS
AUCKLAND, NEW ZEALAND
Left Push Button = Light On/Off Switch
Second Push B utto n = Fan On High Speed
Third Push Button = Fan On Second Speed
Fourth Push Button = Fan On Low Speed
Fifth Push Button = Fan Off
O P T I O N A C C E S S O R I E S
RECIRCULATED
Use manufacturer Product Code.
1744 Recirculation Kit
MANUFACTURED FOR
Electrical Rating:
372W (1.55A)
Max. at 230-240V 50Hz
BY:
ROBINHOOD LIMITED
ISO9001 Certified
I N S T A L L A T I O N
MODEL NUMBER 80078 RH900CB.
BULB
PLEASE READ THE ENTIRE INSTRUCTION BEFORE INSTALLING THE CANOPY
P R O D U C T
I N S T R U C T I O N
D I M E N S I O N S
320mm
900mm
280mm
500mm
104835 issue B
ECN 05 048