MTD Series A4 Operator's Manual page 8

co
R
=4
z
I
z
-4
m
O
z
=o
t_
-4
(OK)
15° Slope
X
(TOO STEEP)
15° Slope
_ Figure 1
USE THiS SLOPE GAUGE TO DETERMINE
iF A SLOPE iS TOO STEEP FOR SAFE OPERATION[
To check the slope, proceed as follows:
1. Remove this page and fold along the dashed line.
2. Locate a vertical object on or behind the slope (e.g. a pole, building, fence, tree, etc.)
3. Align either side of the slope gauge with the object (See Figure 1 and Figure 2 ).
4. Adjust gauge up or clown until the left corner touches the slope (See Figure 1 and Figure 2).
5. If there is a gap below the gauge, the slope is too steep for safe operation (See Figure 2 above).
15°
das2ed line
Figure2
WARNING! Slopes are a major factor related to tip-over and roll-over accidents which can result in severe injury or death.
Do not operate machine on slopes in excess of 15 degrees. All slopes require extra caution.
Always mow across the face of slopes, never up and down slopes.