Craftsman 316.794450 Operator's Manual page 6

Sears universal 2-n-1 blower attachment

Hide thumbs Also See for 316.794450:

Available languages

I WARNING:

To prevent serious personal injury or

damage to the unit, make sure the nozzle is properly

installed before operating the unit.

Groove

Bu_on

WARNING:

To prevent serious personal injury, take the

following steps before installing or removing nozzles:

• Stop the unit and allow the impeller to come to a

complete stop

Disconnect the spark plug wire or disconnect the unit from

the power source before installing or removing nozzles.

Housing

Nozzle

WARNING:

To prevent serious personal injury, do not

insert hands into the nozzles or housing when removing or

installing nozzles.

iNSTALLiNG A NOZZLE

1. Align the button on the inside of the nozzle with the groove on

the housing (Fig. 1).

2. Push the nozzle onto the housing and turn the nozzle clockwise

until it locks into place (Fig. 2).

NOTE: The button should face up when the nozzle is properly

installed.

Fig. 1

Lock

Fig. 2

REMOVING

A NOZZLE

1. Turn the nozzle counterclockwise

approximately

45 ° until the

button unlocks from the housing (Fig. 2).

2. Pull the nozzle off of the housing (Fig. 2).