MTD Series 830 Operator's Manual page 10

c. Attach c enter topofbag from inside o fframe.
Before attaching the grass catcher, themulching baffle
must beremoved.
a. Liftrear d ischarge door.
b. Remove mulching baffle. See Fig. 3-5.
a_
b.
Figure :3-3
Hold blade control against upper handle.
Pull starter rope out of the engine. Release blade
control.
c. Slip starter rope into rope guide.
d. Tighten wing nut.
GrassCatcher
Follow steps below to assemble the grass catcher. Make
certain bag is turned right side out before assembling
(warning label will be on the outside).
a. Place bag over fra me so that its black plastic side is
at the bottom. See Fig. 3-4.
Figure 3-4
b. Slip plastic channel of grass bag over hooks on the
frame. All the plastic channels except center top of
bag attach from outside of frame.
3_
f
Figure 3-5
Follow the steps below to attach the grass catcher:
a. Lift rear discharge door. See Fig. 3-6.
\
Figure 3-6
b. Place grass catcher on the pivot rod. Let go of
discharge door so that it rests on the grass catcher.
_ ARNING: Never operate mower unless the hooks
on the grass catcher are firmly seated on the pivot
rod and the rear discharge door rests firmly against
top of the grass catcher.
'°1
SECTION
3 -- ASSEMBLY &
SET-UP