Advertisement
our 1Y remote
can be set to
work your VCR or Cable
Converter
by what is called the
SEARCH
method.
<_
Press the POWER button on
the VCR or Converter to turn the
unit ON.
If the "REMOTE
CODE"
number
method
shown
in the previous
section did not set your remote to
work your VCR or Converter,
then
follow
the easy steps listed below.
Please
read through
steps 1-4
before
beginning.
<_
Stand at least six feet away
from the front of the VCR or
Converter.
Point the remote toward the unit.
tlOLD
DOWN the A/CH and
the desired System (VCR or
CBL-Converter)
buttons at the
same time. KEEP HOLDING
BUTI'ONS DOWN.
<_
Watch the Channel Indicator
I
n the unit.
Channel Numbers will SCAN UP
when the unit has been identified.
This may take up to two minutes.
<_
Release the
System
A/CH and
(VCR or CBL) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Converter.
I'_ClIICIIIDCl,
i.l Illll]Ut'd
Ol
g two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels.
If you do the
remote
may pass up the right code
and another
two minute search
cycle will have to he repeated.
If no channel
change happens
within two minutes,
repeat steps
1-4. Should
a channel change
still
not occur, the remote will not
work with the desired
unit.
CABLE
CON VERTER
..... iiiiiiiiiiiiiiiiiiiiiiiiiiiii!iii!i!i!iiiiiiiiiiiiiiiiiiiiii
....
22
T
Six Feet
(minimum)
Advertisement
