Remote - Philips 15PF9936/37 Directions For Use Manual

PHILIPS
uick Use and Hookup Guide
Important Notice/Warning ..................... 1
Basic TV Operation .......................... 1
Remote Battery Installation ................... 1
Remote Control Button Descriptions ............ 1
Hooking up the Television
Basic Cable/Cable Box TV Connections ......... 2
Basic Antenna TV Connections ................ 2
AV1 Input Connections ...................... 3
Component Video Input Connections ........... 3
High Definition Input Connections ............. 3
Headphone/Sub-woofer/Data Jacks ............. 3
PC (Monitor) Connection .................... 4
AV2 Input Connections ...................... 4
AV3 Input Connection ....................... 4
Monitor Output Connections .................. 4
IMPORTANT
NOTE: This owner's manual is used with several
different television models. Not all features (and
drawings) discussed in this manual will necessarily
match those found with your television set. This is
normal and does not require that you contact your
dealer or request service.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD DO NOT EXPOSE THIS UNIT TO
RAIN OR EXCESSIVE MOISTURE.
Tt 1is
he
;7;
LCD television has a set of controls located on the top of
cabinet for use when the remote control is not needed.
Press the POWER button on the fiont of the TV cabinet to
turn the TV ON.
Note: With AutoChron ON, the TV will search for a PBS chan-
nel to set the clock before powering itself on. This can take a
few seconds.
Press the VOLUME + button to increase the sound level or
the VOLUME - button to lower the sound level.
Pressing both buttons at the same time will display the
onscreen menu. After you are in the menu, use these buttons to
make adjustments or selections.
Press the CHANNEL + or - button to select TV channels.
Use these buttons to make adjustments or selections in the
onscreen menu.
There is also a set of Audio and Video Input ,jacks located on both sides
and the bottom of the television cabinet. Refer to the Audio/Video
Hookup sections within this Guide.
o load the stq_plied hatteries into the remote"
Remove the battery compartment door on the back of the
remote.
Place the batteries (2-AA) in the remote. Be sure the I+) and
( ) ends of the batteries line up COtTectly (the inside of the case
is marked).
Reattach the battery compartment door.
Volume and Channel buttons are located
on the top of the television cabinet.
Remote
Sen_of _,Vl ndo \\
DC Input located on the
bottom jack panel of the TV
J
, ,_ ',,_,,' _,
, .E.o
Remote Sensor \\ redo\\ on the
tront ot the television \\ hen u_lng
the remote control to operate the
television
Remote Control
(sho\\ 11 frolll
the bottom)
2 "'AA'" Batteries
Po\\ el" Cord and Adapter
Battery Compal'tmer_t Door
\
Battery Compamnent
PIP Button - When in the PC Mode, pressing the PIP button will bring ug
smaller second screen window to view prognamming while using tt_e TV as a com-
puter monitor.
Accessory Device alal, l, I_, I_l_, It Buttons- Pre_ to rewind,
fasfforward, or pause/freeze a videotape, or DVD.
TV/DVD/ACC Mode S_vitch - Slide to the TV position to control TV func-
tiom to the DVD position to control DVD Player functions, or to the ACC position
to control the functions of accessory devices (a cable converter, DBS, or VCR, for
example).
Program List Button - Pre_ to display a list of channel numbers and their
names. Each channel will appear as a selectable menu item. Refer to the ProgTam
Li,,t section within the Dtmtrtons.lo_ Use manual ,,upplied with the TV for detailed
in,,truction,,.
Sleep Button - Press to set the TV to automatically turn if, elf OFF at a given
amount of time.
TV/VCR (A/CH) Button - TV/VCR Press while in the VCR mode I
indicator on the flont of the VCR will light) to view the playback of a tape. Press
again to place in the TV position (the VCR indicator light will go off) to view one
progTam while recording another progTam. A/CH Press to toggle between the cur-
rently
viewed channel and the previou,,ly viewed channel.
Auto Sound Button - Pm,,s to ,,elect an AutoSound zxzcontrol. Choo,,e from
throe factoDr-,,et control,, (VOICE, MUSIC, and THEATRE) and a PERSONAL to
tailor the TV sound to enhance the particular type of progrmn you are watching.
Menu (Select) Button - Pres_ for the on,,creen menu to appear Pms,,ing the
menu button alter menu selection,, are made will eliminate the menu flom the dis-
play.
Active Control Button - Pres,, repeatedly to toggle the Active Control to ON or
OFF. When ON, the sharpness and noise reduction will be continuou,,ly monitored.
Cursor Buttons CLeft,Right, Up, Dmvn) - Pre,, these button_to highlight,
,,elect, and adju,,t items on tim TV's on,,creen menu.
Volume {+) or {-) Buttons - Pre,,,, to adju,,t the TV ,,ound level.
Mute Button
- Pre,s to tuna the TV ,,ound OFF. Pre,,,, again to return tim ,,ound
it,, previous level.
Status/Exit Button - Pres, to ,,ee tim cunent channel number on tim TV ,,creen.
Al,,o pre,,,, to clear the TV ,,creen after control adju,,nnent,,.
I...,=1 PROG LIST CLOCK r- - ,.i
TV,VCR SOURCE FORMAT
@®@
q)®@
®®0,,,
STATUS,EXIT SURF
@
Button - Press to turn the TV ON and OFF.
Position Button - When using the PC Mode and the PIP window is present
on the screen, press the PoMtion button to move the PIP window to any of the
four corners.
CC Button - Press to select Closed Captioning options wnhin the menu.
(See the DirectionL/or Use manual for details.)
Clock Button - Press the CLOCK bunon to access the onscreen Clock
menu.
Format
Button - Press to toggle the different screen format options.
Source Button - Press to toggle between the different AiV Input jack con-
nections and the currently tuned channel.
TM
Picture Button - Press to select an AutoPicture control. Choose
fiom tour factory-set controls (MOVIES, SPORTS, WEAK SIGNAL, and
MULTI MEDIAl and a PERSONAL control that you set according to your
own preferences through the onscreen PICTURE menu. The four factory-set
controls will tailor tl_e TV picture so as to enhance the particular type of pro-
gram you are watching, or to maprove the p_cture of a progranl that has a weak
signal.
Surf. Sound button
- Press to set various factory Incredible Surround
Sound hstening modes. (Refer to tl_e Incredible Surround section within tlae
Directions'Jot Use for detailed lnstructions.)
Channel (+) or (-)
Buttons - Press to change the tuned channel.
Mode buttons - Press to directly enter a N_ecific mode, use the PC bunon to
place the TV m the PC (computer monitor) mode, press the HD button to
place the TV m the HD (high definition) mode, press the Radio button to place
the TV m the FM Radio mode, or the TV bunon to place the TV back to ns
normal TV mode.
Number
Buttons - Press tlae llunlber buttons 1o select TV channels. When
selecting single-digH channels, press the number of the desired channel. The
TV will pause for a few seconds and then tune to the selected channel. (Note:
You can press 0, then the number also.) For channels 100 and above, first
press 1 then the nex:t two numbers of tl_e desired channel.
Surf Button - Press to select previously viewed channels. You can place up
to 10 channels in memory. Then by pressing the SURF burton you can quickly
view the select channels. (See the "'Using the Channel Surf Control" section m
your hwrt_ctionL/or Us'e manual to see how to select a series of channels
tlSi]lg the Surf button.)