Connect Theac Power Cord; Manage Cables; Switch On Thetv - Magnavox 19MD358B User Manual

4.4
Connect the AC power cord
WARNING:
Verify that your voltage corresponds with
the voltage printed at the back of theTV.
Do not insert theAC power cord if the
voltage is different.
To connect the AC power cord
4.6 Switch on theTV
Before you switch on theTV, check that the mains
cord is properly connected. Press POWER
button at the front side of theTV, or press power
the remote control. TheTV normally takes 10-15
seconds to start up and the following screen appears
the first time you turn on theT_(
f i_
1. Locate the power connector at the back of the
T_ The location of the power connector varies
according to TV model.
2. Insert the AC power cord fully into the TV
power connector-.
3. Connect the AC power cord plug to the power
outlet. Ensuring that the cord is tightly secured
at both ends.
Follow the on-screen instructions t o selectyour
languageand complete your TV setup. Installation
takes approximately 10 minutes.
Note: If you connect your TV to a cable receiver
box or satellite set-top box, you do not need
to install channels. Press the red button on the
remote control to exit the channel installation
stage of the setup.
4.5 Manage cables
Route your AC power cord, antenna cable and all
other device cables through the cable holder at the
back of the TV.The holder helps keep your cables
tidy and easily manageable.
r"
........................................................................................ /
EN-IO