Features - GE WCRE6270K0WW Owner's Manual

About washer features.
3 N
4 OPTIONS
AUTO SeAS FABRIC SOFTenER
_ E×TEN_EO SP_ AUTO + _d _S_
SOAK
The Fabric Softener Dispenser (on some models)
The fabric softener dispenser automatically releases liquid fabric softener at the proper time
during the cycle.
Do not stop the washer during the first spin. This will cause the dispenser to empty
too soon.
Never pour fabric softener directly on clothes. This mug cause stains on gout clothing.
To use, follow these steps:
-] ift the tab on the fabric softener
dispenser top.
Heasure out fabric softener into
the cap and pour the softener into
the dispenser top. The fabric softener
will drain into the receiving cup inside
the dispenser.Use only "Ultra" or
concentrated fabric softeners.
NOTE:Overfilling the dispenser will cause
fabric softener to drain out of the holes in the
side of the infusor when filling. Do not overfill.
%
Pushdown on the tab to close
the dispenser top. Hake sure the tab
is pushed down fully and snaps shut.
E] Select FABRIC SOFTENER from OPTIONS
on the control panel.
6
TurningTabs
TurningTabs
Cleaning the Fabric Softener Dispenser
(on some models)
The Fabric Softener Dispenseris self cleaning. This dispenser does not require regular cleaning
like standard fabric softener dispensers.Wipe down exterior surfaces of the dispenser
as needed. If cleaning of the internal dispenser components is needed,follow these steps
after the wash cycle iscomplete:
E]
Lift the dispenser top tab and turn the top
counterclockwise using the 2 turning tabs
shown. Lift the dispenser out of the
Infusor
TM.
@
Clean out any buildup from inside the
Infusor
TM
with a soft cloth or toothbrush.
Ensurethe three rectangular holes
in the bottom which allow the fabric
softener to drain are not blocked.
Gently pull the cap away from
the dispenser cup to separate.
Wipe surfaces with a soft cloth or soak
the parts in a solution of I gallon warm
water, 1/4 cup liquid detergent and I cup
bleach. Ensurethe small hole in the top
surface of the cap and associated tube
are not obstructed.
Reassemblethe dispenser cup and cap
by snapping them together.
Placethe dispenser assemblLjinto
the Infusor
TM.
Turn the top clockwise
using the 2 turning tabs shown. Push
down on the tab to close the dispenser
top. Hake sure the tab is pushed down
fully and snaps shut.