Table of Contents
Advertisement
CARE AND CLEANING
(continued)
Drawer Removal
Drawers
at bottom of fresh food compartment
will stop
before coming all the way out of refrigerator
to help
prevent contents from spilling onto floor. Drawers
can
easily be removed
by grasping the sides and lifting up
slightly while pulling past "stop"
location.
To remove
drawers
when
the refrigerator
door
cannot be opened
all the way:
1, Remove food from shelf above sealed vegetable
drawer and take out shelf. Take food off the glass
cover and out of the drawer.
2. Remove the flexible
Drawer
gasket
at the rear of the _ppert
vegetable
drawer. Lift
b
each end straight up
until the slots on the
gasket
are
free
of
drawer support tabs.
\\
Gasket
3. Pull the drawer partway
out. Reach in, push the rear
of the glass up and, at the same time, push it back
until it clears front-corner
retainers.
4. Tilt and remove the cover. Avoid cleaning
the cold
glass cover with hot water because the extreme
temperature
difference
may cause it to break.
5. Pull the drawer forward,
lift the front to clear stops,
and remove the drawer. If the refrigerator
door
doesn't
open completely,
pull the drawer out until it
hits the door. Then lift the drawer up until it is higher
than the drawer supports,
tilt it and take it out.
6. If tape holds the Convertible
Meat Pan cover to the
drawer supports,
remove the tape. Pull the drawer
partway out. Reach in, push the rear of the glass up
and, at the same time, back until it clears the front-
corner retainers.
7. Tilt and remove the cover.
8. Tilt and remove the drawer. After
cleaning,
replace
in reverse order.
When replacing
the
drawer (on some models)
make sure you slide it
through both drawer
guides on the left side.
Drawer
When drawers and covers are back in place, reinstall
the gasket at the rear of the sealed vegetable
drawer. Fit
the end of the plastic drawer support into the slot on the
gasket, with the rubber gasket flap facing you. Make
sure the gasket snaps into place.
Light Bulb Replacement
Fresh Food ComDartment-Uj)per Light
1. Unplug refrigerator.
2. To align the control
knob properly, note
position
of numbered
control for proper
reassembly
and pull
off knob.
3. Pull bottom of light
_in_
Grooved 1[ _
_
Pin
Retainer--II
_L "__1,_',_'_,,.
\
one on
each
II _
%, %
\
panel down about 1/4"--just
enough to disengage
lip at rear from grooves in retainers
on rear wall.
4. Lift panel to disengage
top from pins on side walls;
remove panel.
After replacing with same size bulb, reinstall panel
(hang top on pins; pull bottom down, push it back
and release it to let lip engage grooves in retainers).
Replace temperature
control knob in OFF position,
turn it to previous setting, and plug refrigerator
back in.
10
Fresh Food ComPartment-
Lower
Light
(on some models)
This light is located behind a shield at the rear
of the fresh food compartment
1. Unplug refrigerator.
2. Grasp the top edge of the shield and lift it up
and forward to free its top edge.
3. After replacing
with the same size bulb, hook
the top of the shield back in place.
Freezer
Compartment
1. Unplug refrigerator.
2. Remove shelf just below light
shield. (Shelf will be easier to
remove if it is emptied first.)
3. Pull plastic light shield toward
you. (It will bend to free tabs
from grooves.)
After replacing with same size bulb, reinstall shield
and shelf and plug refrigerator back in.
Advertisement
Table of Contents
