GE AHH24DQH1 Owner's Manual And Installation Instructions page 11

Installation Instructions
[] INSTALL OUTER CASE IN WINDOW
D Thread nut onto bolt, then thread the bolt into
the triangle bracket as shown in the figure
below.
rE1 Attach triangle bracket onto bottom of case
using three type B screws for each bracket.
Make sure that the bracket is close enough to
the outside wall that the bolt con touch. Adjust
bolt so that it is snug against the outside wall.
1
NOTE: A block of wood con be placed between
the bolt and the outside wall if the bolt rests
between studs.
[] COMPLETE INSTALLATION
r_ Insert the foam seal behind the top of the lower
window sash and against the glass of the upper
window.
B. Foam seal
r_ place the window lock bracket as shown. Use
a 1/8" drill bit to drill a starter hole through the
hole in the window lock bracket and into the
upper window.
ACAUTION:
To prevent broken glass or damage to windows,
on vinyl or other similarly constructed windows,
attach the window locking bracket to the
window sidejamb with one type B screw.
D Attach the window lock bracket to the upper
window with a type C screw to secure the
window in place.
Vinyl
Wood
11