GE JGS905 Owner's Manual page 33

ge.com(U.S.)
www.GEAppliances.ca (Canada)
Possible Causes What To Do
Control signals after You forgot to enter a • Touch tile BAKE pad and desired temperature or
entering cookingtime
bake temperature or
the SELFCLEAN LO/STD
pad and desired clean time.
or start time cleaning time.
Display goes blank A fuse in your home may * Replace tile fi/se or reset tile circuit breaker:
be blowlz or the circuit
breaker tripped.
The clock is in the
* See
the
Special features of
your oven
control
section.
black-out mode.
Display
flashes
Power failure.
* Reset
the clock.
Unable to get the Oven control pads were * The BROIL HI/LO and BAKE pads must be touched at
display to show "SF" not touched properly, the same time and held tm 3 secm_ds.
Power outage,
Power outage or surge.
* Reset
the clock. ]f the oven was in use you must reset
clock flashes
it by, touching,
the
CLEAR/OFFpad,
, settiuo_ the
clock
and resetting any cooking flu]orion.
"Burning" or "oily"
This is normal in a new oven • To speed the
})I'OCeSS,
set a self=clean cycle foF _1
odor emitting from
and will disappear in time. minimum of 3 hours. See the
Using the self-cleaning
the vent oven section.
Strong odor
An odor from the insulation * This
is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
33