Level The Range - GE C2S980 Owner's Manual And Installation Instructions

Read these instructions completelg and carefullg.
[] Check Ignition of Surface Burners
Operation of all cooktop burners should be checked
after the range and gas supplg lines have been
carefullg checked for leaks.
Electric Ignition
Select a top burner knob and simultaneouslg
push in and turn to LITE position. You will hear
a clicking sound indicating proper operation of the
spark module. Once the air has been purged from
the supplg lines, burners should light within
4 seconds. After burner lights, rotate knob out
of the LITE position. Trg each burner in succession
until all burners have been checked.
Oualitg of Flames
The combustion qualitg of burner flames needs
to be determined visuallg.
(A) Yellow flames--
Call for service
(B) Yellow tips an
outer cones--
Normal for LP gas
(C)Soft blue
flames--Normal
for natural gas
If burner flames look like(A),call for service.Normal
burner flames should look like (B)or (C), d epending
on the type of gas you use.
With LPgas, some gellow tipping on outer cones
is normal.
[]
Level the Range
[] Install the oven shelves in the oven and
position the range where it will be installed.
range
(on some models}
Raise_l! °wer
range range
(on some models)
[] Check for levelnessbg placing a spirit level
or a cup, partiallg filled with water, on one
of the oven shelves.If using a spirit level,take
two readings-with the level placed diagonallg
first in one direction and then the othen
I_q Removethe lower oven drawee See the Care
and cleaning of the range section. Thefront
leveling legs can be adjusted from the bottom
and the rear legs can be adjusted from the top
or the bottom.
[] Use an open-end or adjustable wrench to
adjust the leveling legs until the range islevel.
[] After the range is level, slide the range awag
from the wall so that the Anti-Tip device can
be installed.
51
O
@
a
e,,I-
LQ
q-
0
E
Is}
0
0
0
e_e