Advertisement
Available languages
Available languages
GEAppliances.com
Do Not Operate in FreezingOutdoor Conditions
This cool-only air conditioner
was not designed
for
fleezing
outdoor
conditions.
It must not be used in
fleezing
outdoor
conditions.
Remote Control
To ensure
proper
operation,
aim file remote
control
at the signal receiver
on the air
conditioner
The remote
conuol
signal has a range of
up to 20 feet.
Make sure nodfing
is between
file air conditioner
and the remora
control
that coukt block the
signN.
Make sure batteries
are flesh and instaUed
correc@
_ksindicated
on the remote
control.
Cool Mode
Use the Coolmode
at Low, Met/, High or Auto Fan
Speed for cooling.
Use the Temperature Increase A /
Decrease
W pads to set the desired
mmperamre
between
62°F and 86°F in 1 °F increments.
An electronic dlermostat is used to maintain file
room
mlnpemlalre.
The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the themlostat at a lower number and the indoor
air will become cooler Set the themlostat at a higher
number and the indoor air will become wam_e_:
NOTE: If theair conditioner i s off andis thentumedon
whileset toa Coolsettingor if tumedfroma fansetting
toa Coolsetting,it maytakeapproximatdg 3 minutes
forthecompressor to startandcoolingtobegin.
Cooling Descriptions
For Normal Cooling--Select the Cool mode and
High or Med fire with a middle
set temperature.
For Maximum
Cooling--Select
the Cool mode
and High f_m wkh a lower set mmperamre.
For Quieter and Nighttime
Cooling--Select
the
Cool mode and LOWf_m wkh a middle
set
temperature.
Energy Saver Mode
Controls
the f_m.
0N--The
fire will cycle on and offwith
the
compressor
This results in wider variations
of room
mmpemmre
and humidity.
Nomm/ly
used when
the
room is tmoccupied.
NOTE: Thefan 1778}/continue t o run
for a short time after the compressorcycles off
OFF--The fire runs all file time, while the
compressor cycles on and off.
Fan Mode
Use die Fan Mode at tow, Med or High fire speed
to
provide
air circulation
and filtering
wifllout
cooling.
Since fire-only settings
do not provide
cooling,
a Set mmperamre
cannot
be enmred.
The room
temperature
will appear
in the display.
NOTE:Auto FanSpeed is available in theFan Mode.
Auto Fan Speed
Set to AutO fire speed
for the f_m speed
to
automatically
set to file speed needed
to provide
optimum
comfort
settings with the set mmpemmre.
If the room needs
more
cooling,
the f_m speed
will automatically
increase.
If the room needs
less
cooling,
the f_m speed will automatical
b decrease.
NOTE:Auto FanSpeed is available in theFanMode.
Power Outage Recovery Feature
In file case of a power outage
or interruption,
file
unit will automaficall),
restart in file settings
last
used a[_er the power is restored.
If the De/el/1-24hr
feature
was set, it will resmne
cotmtdown.
You me}.
need
to set a new dine if desired.
5
Advertisement
