Troubleshooting Guide - Panasonic DMP-BD77 Operating Instructions Manual

Troubleshooting guide

Reference
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
Do you have the latest firmware installed?
Firmware updates may be released to correct
operating irregularities that are discovered with
certain movies. ( 12)
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
∫ Unit doesn't respond to remote
control or front panel buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
∫ Cannot eject disc.
The unit may have a problem.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
– "00rEt" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control or [Í/I] on the unit until "06FtO" is
displayed on the unit's display.
3 Press [OK] on the remote control or
[< OPEN/CLOSE] on the unit.
General operation
To return to the factory preset.
Select "Yes" in "Default Settings" in the Setup
menu. ( 28)
To return all settings to the factory preset.
Reset the unit as follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
– "00rEt" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control or [Í/I] on the unit until "08FIn" is
displayed on the unit's display.
3 Press and hold [OK] on the remote control or
[< OPEN/CLOSE] on the unit for at least
5 seconds.
The remote control doesn't work properly.
Change the batteries in the remote control.
( 4)
The remote control and main unit are using
different codes. If "SEt " is displayed on the
unit's display when a button is pressed on the
remote control, change the code on the
remote control. (
The TV tuner mode is not displayed when the
TV is switched on.
This phenomenon may occur, depending on
the TV setting, when "Quick Start" is set to
"On".
Depending on the TV, this phenomenon may
be prevented by reconnecting the HDMI cable
to a different HDMI input terminal or by
changing the HDMI auto connection setting.
You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory preset.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
– "00rEt" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote
control or [Í/I] on the unit until "03VL" is
displayed on the unit's display.
3 Press [OK] on the remote control or
[< OPEN/CLOSE] on the unit.
28, 32)
29
VQT3V42