Filter Timers; Checking The Filter Timers - Miele DA 249-4 Operating And Installation Instructions

Operation

Filter timers

Grease filter
A timer monitors the hours of fan
operation. The indicator for the grease
filter will light after 30 hours of
operation. The grease filter must then
be cleaned.
After the grease filter have been
cleaned and put in place, the grease
filter timer must be reset.
^ To do this, press the grease filter
button for about 3 seconds.
The indicator will go out.
Charcoal filters
Recirculation mode
The timer for the charcoal filter is not
preset. Please program this timer, see
"Operation/Reprogramming the
charcoal filter timer".
The charcoal filter indicator will light
once the selected time has elapsed.
The charcoal filters must then be
replaced and the charcoal filter timer
must be reset.
^ To do this, press the charcoal filter
button for about 3 seconds.
The indicator will go out.
14

Checking the filter timers

To check the percentage of time
already used:
^ Press the On/Off button to turn the
fan on.
^ Press the grease or charcoal filter
button.
The number of flashing "–/+" indicators
show the percentage of programmed
hours that have been used.
1 indicator = less than 25 %
2 indicators = less than 50 %
3 indicators = less than 75 %
4 indicators = less than 100 %
This information will remain stored in
memory in the event of a power failure.