Marantz NR1604 Owner's Manual page 95

5
o p
Use to select the
configuration of the connected
speakers, and then press
ENTER
.
Surround Back Setting for 7.1-channel playback using surround
back speakers.
Setting to assign the unit's built-in power amplifier
ZONE2
for ZONE2 and output the audio in stereo.
Setting to use the front speakers via the bi-amp
Bi-AMP
connection.
Front B Setting to use the second set of front speakers for
playback.
Front Height Setting for 7.1-channel playback using front height
speakers.
6
o BACK
Press or to exit the "Amp Assign" setting.
DVD
7
Set up "Channel Select"
ui
Use to select "Channel Select", and then press
ENTER
.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
Channel Select
Subwoofer Measure
Surround Back Measure(2spkrs)
8
ui
Use to select a channel, and then press
Select for setting the front speakers to be used. In this
Front
case, go to step 9.
• "Front" can be set when "Assign Mode" is set to
"Front B".
Select for no subwoofers to be used. In this case, go
Subwoofer
to step 10.
Surround Select the number of surround back speakers to be
Back
used. In this case, go to step 11.
• "Surround Back" can be set when "Assign Mode" is
set to "Surround Back".
92
9
o p
Use to select a front speaker, and then press
ENTER
.
Select this to use front speaker A.
A
B
Select this to use front speaker B.
A+B Select this to use front speakers A and B simultaneously.
10
o p
Use to set whether or not a subwoofer channel is
measured, and then press
Measure Set for measuring a subwoofer.
Set for no measuring of a subwoofer.
Skip
11
o p
Use to set whether or not a surround back
channel is measured, and then press
Measure
Set for measuring two surround back speakers.
(2spkrs)
Measure
Set for measuring a surround back speaker.
(1spkr)
Skip Set for no measuring of a surround back speaker.
12
o BACK
Press or .
Preparation
Proceed to page 24
NOTE
After performing Audyssey ® Setup, do not change the speaker
ENTER connections or subwoofer volume. In event of a change, perform
.
Audyssey ® Setup again.
Set up speakers
ENTER
.
ENTER
.
step 5.