Advertisement
Reversing switch action
This
tool
has a
reversing switch
to
change
the direction of rotation. Move the revers-
ing switch lever to the "FWD" position for
clockwise rotation or the "REV" position
for counterclockwise.
CAUTION
:
Always check the direction of rotation before operation.
*Use the reversing switch only when the tool comes
to a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
Operation
Fit the screw on the point of the bit and
place the point of the screw on the surface
of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw
the tool
as
soon
as
the clutch cuts in. Then
release the trigger.
CAUTION
:
Use the proper bit for the head of the screw that you wish to use.
When fitting the screw onto the point of the bit, be careful not to push in on the screw.
If the screw is pushed in, the clutch will engage and the screw will rotate suddenly. This
could damage
a
workpiece or cause an injury.
Do not continue unnecessary clutching operation.
NOTE :
Make sure that the bit
is
inserted straight in the screw head,
or
the screw and/or bit may
be damaged.
7
Advertisement
