Rear Panel Controls - Laney Richter Bass RB5 Manual

REAR PANEL CONTROLS

All controls common - unless otherwise stated
Power inlet socket. Connect to your
1
power source. Make sure the
specified voltage is correct for your
country!
This drawer contains the main safety
2
fuse for the unit. USE ONLY THE
CORRECT SIZE AND RATING OF
FUSE AS SPECIFIED ON THE
PANEL.
Serial Number and model of your
3
unit.
This socket should be used to
4
connect an extension-cabinet. The
impedance of the extension-cabinet
must not be less than 8 Ohms.
Connecting cabinets that have a
lower impedance than 8 Ohms will
result in the amplifier overheating.
Continual use in this manner may
cause permanent damage.
Connecting a cabinet with an
impedance of greater than 8 Ohms
will cause no damage to the amplifier
but will result in a reduced output
level. (When using an extension cabinet the internal speaker remains connected)
Send and return sockets are provided for connecting external effects-units. You can also use the Send socket as a line out if
5
you wish.
Socket for connecting external tuner. This output is taken before any processing so the Volume control may be turned down
6
for silent tuning.
12
1
L Z B 1 2 3 4
2 3 4
L Z B 1 2 3 4
T6.3A L 250V
L Z B 1 2 3 4
5
6