Rear Panel Controls - Laney Richter Bass RB4 Instructions Manual

REAR PANEL CONTROLS

All controls common - unless otherwise stated
Voltage Selection Switch: This is
1
factory set to the correct voltage for
the region the product is supplied to.
If necessary it can be reset by
removing the mains lead and then
loosening (but not removing) the
screws securing the cover. The cover
can then be pivoted away from the
switch which can be moved to select
the alternate voltage. DO NOT
reconnect the mains lead until the
cover is replaced and secured. Please
ensure the correct fuse is fitted (as
printed on the panel) for the voltage
being used.
2
Power inlet socket. Connect to your
power source. Make sure the
specified voltage is correct for your
country!
The main safety fuse for the unit is inside this drawer.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL.
3 Mains Power Switch.
4 Information area relating to the amplifier: Serial Number, Fuse Type & Rating etc
5 This socket(s) should be used to connect an extension-cabinet. The impedance of the extension-cabinet must not be less than
8 Ohms. Connecting cabinets that have a lower impedance than 8 Ohms will result in the amplifier overheating. Continual use
in this manner may cause permanent damage. Connecting a cabinet with an impedance of greater than 8 Ohms will cause no
damage to the amplifier but will result in a reduced output level. (When using an extension cabinet the internal speaker
remains connected)
12
1
2 3 4 5
6
7 8