Fuel Filter; Spark Plug - Shindaiwa EB633RT Owner's/Operator's Manual

fuel fIlTer

Level 1.
Tools required: 200 - 250 mm (8 - 10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved fuel container
fuel fIlTer
DANGer
Level 1.
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling.
Parts Required: Fuel Filter
1. Use a clean rag to remove loose dirt from around fuel cap and
dANGeR
empty fuel tank.
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result.
2. Use the "fuel line hook" to pull the fuel line and filter from the tank.
3. Remove the filter from the line and install the new filter.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the "fuel line hook" to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
NOTE
Federal EPA regulations require all model year 2012 and later gasoline powered engines produced for sale in the
United States to be equipped with a special low permeation fuel supply hose between the carburetor and fuel tank.
When servicing model year 2012 and later equipment, only fuel supply hoses certified by EPA can be used to replace

spArk pluG

the original equipment supply hose. Fines up to $37,500 may be enforced for using an un-certified replacement part.
Level 1.
Tools required: 19mm Spark Plug deep socket, Feeler gauge
spark plug
Level 2.
IMPORTANT
Use only BPMR-8Y spark plug otherwise severe engine damage
Parts Required: Spark Plug
may occur.
1. Remove spark plug , and check for fouling, worn and rounded center
IMPORTANT
electrode.
Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada)
otherwise severe engine damage may occur.
2. Clean the plug or replace with a new one. DO NOT sand blast to clean.
Remaining sand will damage engine.
1. Remove spark plug and check for fouling, worn and rounded
3. Adjust spark plug gap by bending outer electrode.
center electrode.
4. Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
16
0.65 mm
(0.026 in.)
0.65 mm
(0.026 in.)
17