Starting Cold Engine - Shindaiwa EB633RT Owner's/Operator's Manual

After use
Stored fuel ages. Do not mix more fuel than you expect to use in
thirty (30) days, ninety (90) days when a fuel stabilizer is added.
• DO NOT store a unit with fuel in its tank. Leaks can occur. Return
thirty (30) days, ninety (90) days when a fuel stabilizer is added.
unused fuel to an approved fuel storage container.
Storage
Fuel storage laws vary by locality. Contact your local government for
the laws affecting your area. As a precaution, store fuel in an approved,
airtight container. Store in a well-ventilated, unoccupied building, away
from sparks and flames.

sTarTInG Cold enGIne

sTarTInG Cold enGIne
IMPORTANT
Stored fuel ages. Do not mix more fuel than you expect to use in
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting.
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting.
thirty (30) days, ninety (90) days when a fuel stabilizer is added.
Do not allow the rope to snap back in. Always hold the unit firmly.
Do not allow the rope to snap back in. Always hold the unit firmly.
1. Throttle Lever/Stop Switch
1. Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch (B)
Move throttle lever (A) forward to idle position. Slide stop switch (B)
forward to run position.
forward to run position.
2. Choke
2. Choke
Move choke (C) up to "Cold Start" position (
sTarTInG Cold enGIne
Move choke (C) up to "Cold Start" position (
3. Purge Bulb
3. Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Purge Bulb
Do not allow the rope to snap back in. Always hold the unit firmly.
Pump purge bulb (D) until fuel is visible and flows freely in the clear
Pump purge bulb (D) until fuel is visible and flows freely in the clear
fuel tank return line. Pump bulb an additional 4 or 5 times.
fuel tank return line. Pump bulb an additional 4 or 5 times.
1. Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch (B)
4. Recoil Starter
4. Recoil Starter
forward to run position.
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maximum).
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maximum).
2.
Choke
5. Choke
5.
Choke
Move choke (C) up to "Cold Start" position (
Move choke (C) down to run position (
Move choke (C) down to run position (
engine.
engine.
3. Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the clear
NOTE
NOTE
fuel tank return line. Pump bulb an additional 4 or 5 times.
If engine does not start after 5 pulls, move choke to "Cold Start"
If engine does not start after 5 pulls, move choke to "Cold Start"
position, and repeat steps 4 & 5.
position, and repeat steps 4 & 5.
4. Recoil Starter
NOTE
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maximum).
NOTE
Allow engine to warm up before use.
Allow engine to warm up before use.
5. Choke
Move choke (C) down to run position (
engine.
NOTE
If engine does not start after 5 pulls, move choke to "Cold Start"
position, and repeat steps 4 & 5.
NOTE
Allow engine to warm up before use.
12
).
).
).
), and if necessary, restart
), and if necessary, restart
), and if necessary, restart
1 2.6 4
IMPORTANT
1 2.6 4
2 5.2 8
Stored two-stroke fuel may separate.
2 5.2 8
ALWAYS shake fuel container thoroughly
5 13 20
5 13 20
before each use.
Fuel to Oil Mix-50:1 Ratio
U.S.
GAS OIL GAS
Gallons Fl.oz. Liter
1 2.6 4
b
2 5.2 8
b
a
a
5 13 20
b
a
C
C
d
d
C
C
C
e E
d
e
C
e
80
80
160
160
400
400
METRIC
OIL
cc.
80
160
400
11
11
11