Lynx L15ICE User Manual
  1. Manuals
  2. Brands
  3. Lynx Manuals
  4. Ice Maker
  5. L15ICE
  6. User manual

Lynx L15ICE User Manual

Outdoor ice machine
Hide thumbs Also See for L15ICE:
Table of Contents

Advertisement

Quick Links

See also: User Manual and Installation Instructions
User Manual /
Installation Instructions
Outdoor Ice Machine
MODEL:
L15ICE
Lynx Professional Grills
6023-25 Bandini Blvd., Commerce, CA 90040
Service: (888) Buy-Lynx (888-289-5969)
Tel: (323) 838-1770
Fax: (323) 838-1778
www.lynxgrills.com
As product improvement is an ongoing process at Lynx, we reserve the right
to change specifications and design without notice.
Part #31966 Rev. 3-06

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L15ICE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lynx L15ICE

Summary of Contents for Lynx L15ICE

  • Page 1 6023-25 Bandini Blvd., Commerce, CA 90040 Service: (888) Buy-Lynx (888-289-5969) Tel: (323) 838-1770 Fax: (323) 838-1778 www.lynxgrills.com As product improvement is an ongoing process at Lynx, we reserve the right to change specifications and design without notice. Part #31966 Rev. 3-06...

  • Page 2: Important Safety Instructions

    Instruction Manual. Likewise, the owner/manager should not proceed to operate the icemaker until the installer has instructed them on its proper operation. Lynx provides this manual primarily to assist qualified service technicians in the installation, maintenance and service of the icemaker.

  • Page 3: Table Of Contents

    Contents IMPORTANT 1. This booklet is an integral and essential part of the product and should be handed over to the user. Read the warnings contained in this booklet carefully as they give important indications regarding the safety of the installation, use and maintenance. Please preserve this booklet for any further consultation that may be necessary.

  • Page 4: Specifications

    Specifications A. Construction Top Panel Ice Making Mechanism Bin Control Scoop Holder Thermostat Slope Magnet Catch Front Panel Door Control Switch Louver...

  • Page 5: Nameplate Rating

    115-120/60/1 AMPERES 3.4 AMPS DESIGN PRESSURE HI-240PSI LO-120PSI REFRIGERANT 134a 4.2 oz. MOTOR-COMPRESSOR THERMALLY PROTECTED APPROVED FOR OUTDOOR USE Lynx Grills, Inc. Hoshizaki America, Inc. Commerce, Ca Peachtree City, GA www.hoshizaki.com www.lynxgrills.com LISTED ICE MAKER 946Z See the nameplate for electrical and refrigeration specifications. This nameplate is located on the rear panel.

  • Page 6: Dimensions/Connections

    C. Dimensions/Connections...

  • Page 7: Installation Instructions

    II. Installation Instructions A. Checks Before Installation Visually inspect the exterior of the shipping container and report any severe damage to the carrier. WARNING Remove shipping tape(s) and packing as follows. If any are left in the icemaker, it will not work properly. IMPORTANT 1.

  • Page 8: Built-In Installation Site

    2. Built-in Installation Site IMPORTANT 1. Do not let the weight of the counter rest on the icemaker. 2. Do not build in the icemaker in a corner where the door will hit other equipment such as an oven handle or where the icemaker cannot be pulled out for service. INSTALLATION SPACE Height Width...

  • Page 9: Setup

    C. Setup 1. General 1. Make sure the unit is completely unpacked and that all shipping cartons, tapes and packing are removed BEFORE operating the unit. Be careful not to damage the exterior panels when handling the ice machine 2. Position the ice machine in a selected site. Clean the interior with soap and water and rinse thoroughly.

  • Page 10: Water Supply And Drain Connections

    2. Water Supply and Drain Connections WARNING To prevent damage to the freezer mechanism, do not operate this icemaker when the water supply is OFF, or if the pressure is below the recommended minimum water pressure of 10 PSIG (0.7 bar). Stop the icemaker until proper water pressure is resumed. •...

  • Page 11: Electrical Connections

    3. Electrical Connections WARNING THIS APPLIANCE MUST BE GROUNDED. This icemaker requires a ground that meets national and local electrical code requirements. To prevent possible severe electrical shock injury to individuals or extensive damage to equipment, install a proper ground wire to this icemaker. Remove the plug from the electrical outlet before any maintenance, repairs or cleaning is undertaken.

  • Page 12: Startup

    D. Startup Check that shipping tape(s), string and packing are removed before starting the icemaker. 1) Clean inside the storage bin and door. 2) Open the water supply line shut-off valve and plug in the icemaker. 3) Move the control switch to the "ICE" position. The freezing cycle will start automatically. E.

  • Page 13: Cleaning And Maintenance

    A. Cleaning and Sanitizing Instructions WARNING 1. Lynx recommends cleaning this unit at least once a year. More frequent cleaning, however, may be required in some existing water conditions. 2. To prevent injury to individuals and damage to the icemaker, do not use ammonia type cleaners.

  • Page 14: Cleaning Procedure

    2. Cleaning Procedure The cleaning process will remove lime deposits from the water system. 1) Remove all ice from the evaporator and the storage bin. Note: To remove cubes on the evaporator, move the control switch to the "OFF" position and move it back to the "ICE"...

  • Page 15: Sanitizing Solution

    12) Move the control switch to the "WASH" position to circulate clean water for about 5 minutes. 13) Move the control switch to the "OFF" position, then remove the water tank, drain it, and replace it as described in 3) through 6). 14) Repeat 12) and 13) three more times to rinse thoroughly.
  • Page 16 7) Spread out the tabs on both sides to unlock Unlock Unlock the water tank, and pull it out toward you. Soak the water tank in the sanitizing solution for 10 minutes. Frame Pipe 8) Lift off the ice chute from the front frame pipe and then from the rear frame pipe.
  • Page 17 13) Position and lock the ice chute onto the front and rear frame pipes by pushing the chute down until it clicks onto both pipes. Bracket 14) Slide in the water tank along the rails at the Lock Lock bottom of the right and left brackets until it Rail Rail clicks into place.

  • Page 18: Maintenance

    Important Safety Instructions 24) Spread out the tabs on both sides of the water Unlock Unlock tank to unlock it, then pull it out toward you. Drain the tank. 25) After draining, slide in the water tank along Bracket the rails at the bottom of the right and left Lock Lock brackets until it clicks into place.
  • Page 19 This warranty gives you specific legal rights and you may have other rights which vary from state to state. 6. No one has the authority to add to or vary Lynx’s warranty, or to create for Lynx any other obligation or liability in connection with the sale or use of its products.
  • Page 20 • Desert Inn • Hard Rock Hotel • Disney World Questions? Talk to your Lynx Authorized Dealer or visit our website at www.lynxgrills.com Lynx Professional Grills • 6023 E. Bandini Blvd. • Commerce, CA 90040 • (888) 879-2322...

Table of Contents

Save PDF