Configuring And Mounting The Drive; Handling And Static Discharge Precautions - Seagate ST3160022A Product Manual

U Series 9 Product Manual, Rev. C
3.0

Configuring and mounting the drive

This section contains the specifications and instructions for configuring and
mounting the drive.
3.1

Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential
handling and electrostatic discharge (ESD) hazards. Observe the following
standard handling and static-discharge precautions:
Caution:
• The SeaShell™ replaces electrostatic discharge (ESD) bags. The SeaShell
package is a shock-ribbed, transparent clamshell enclosure that limits a
drive's exposure to ESD and also protects against external shocks and
stresses. The design permits attaching cables, software loading and label/
barcode scanning without removing the drive from the SeaShell. This
minimizes handling damage. Keep the drive in the SeaShell package until
you are ready for installation.
• Before handling the drive, put on a grounded wrist strap, or ground yourself
frequently by touching the metal chassis of a computer that is plugged into
a grounded outlet. Wear a grounded wrist strap throughout the entire
installation procedure.
• Handle the drive by its edges or frame only.
• The drive is extremely fragile—handle it with care. Do not press down on the
drive top cover.
• Always rest the drive on a padded, antistatic surface until you mount it in the
computer.
• Do not touch the connector pins or the printed circuit board.
• Do not remove the factory-installed labels from the drive or cover them with
additional labels. Removal voids the warranty. Some factory-installed labels
contain information needed to service the drive. Other labels are used to
seal out dirt and contamination.
21